Episode 18 – Ceilings Installation

In this episode, we are progressing with the ceilings installation. Today, Jase came to put a few ceiling batons up and stuff like that in the kitchen because tomorrow morning he’s going to stick it up. He stuck all those up, ready to go. As you can see, Pete’s got all the stuff here for
Continue Reading …

Episode 17 – Door Update and Electrics

In this episode, we give you an update on the door and electrics work. It was a bit of a rainy old day in Perth. It’s been a while since we had some decent amount of rain. Brendo has cut the door through, as you can see, Brendo and Ben, getting that in. Looking great.
Continue Reading …

Episode 16 – Securing Ceiling Beams

In this episode, we have finished securing the ceiling beams. Check it out! We’ve got all the beams in there secure, so that’s great. One side was a lot easier because we could screw into the bottom the channel here, to bolt it in place. So that was heaps easier. But with the other side,
Continue Reading …

Episode 15 – Floor Joists Install

In this episode, we are installing the floor joists. Check it out! It’s the day after we installed the C Channels. We’ve put the one in the centre first. We’ve had to get that dead square using our Pythagoras theory. One of those things we learned at school. That’s the one there that we’ve laid
Continue Reading …

Episode 14 – C Channel Install

In this episode, we are installing the C Channels. We’re just going to start putting the C channels along the walls. What we’ve done back in the day was we marked out where all the bearers had to sit with a 450 centre. And then we had to figure out how long they were going
Continue Reading …

Episode 13 – Tiling and Floor Protection

We’re starting the new year with the tiling done and putting up the floor protection. Check it out! Tiling Done We’ve done another stage, which has been pretty exciting. We managed to get the tiling done. Now a little bit back to front. We would have liked to get all these ceiling joints and stuff
Continue Reading …

How to Work Your Retic with Low Pressure

Do you have a retic system that doesn’t work correctly? It might be because that retic needs more pressure. Check out this video where we sort out a similar issue. The Issue We just had a job in Maida Vale, just off Old Maida Vale Road, near the BP. It had crazy pressure, well over
Continue Reading …

Episode 12 – Water Services and Tiling

We finished putting all the water services and started the tiling! Check out the video below. We’ve just finished up putting all the water services in the wall, the taps and everything, so we’ll show you how it all turned out. We haven’t cemented it in yet, as we’ve just had to get it all
Continue Reading …

Episode 11 – Flyover Warehouse

Would you like a drone flyover footage of the warehouse? Do you remember in that movie Top Gun when Maverick requests a flyby for the tower there? He probably just wanted to check out the gutters, made sure they were not full of leaves or anything like that, and permission was denied. So he said,
Continue Reading …

How to Replace Hot Water System on Winnebago

Today we are going to be working on this Winnebago. It has an old hot water system that needs to be replaced. We’ve ripped out the old hot water system out of the Winnebago. It used to be sitting in this hole here. Here’s the gas side of it. The first thing we got to
Continue Reading …